Peter A Paul SJ Lüthy H Schärer P 1997 Curing dentine bonding agents create a film thickness on the surface of teeth which are prepared for all-ceramic crowns. The aim of this study was to investigate if the film thickness of dentine bonding agents (DBAs) is acceptable with the fit of definitive restorations of 50-100 microm. AllBond 2, Syntac, ART Bond, P-Bond (an experimental DBA), and the Primer of AllBond 2 were applied onto teeth which were prepared with standardized all-ceramic crown preparations. The DBAs were applied onto the prepared tooth surfaces according to manufacturers' instructions and under a standardized simulation of intrapulpal pressure. After curing the DBAs, the teeth were cut mesiodistally and orolingually and the film thickness was measured under a light microscope. Only the film thicknesses of AllBond 2 and P-Bond were low enough and, therefore, would enable curing to take place immediately after their application. https://sonar.ch/global/documents/55168 eng info:eu-repo/semantics/altIdentifier/doi/10.1046/j.1365-2842.1997.00547.x info:eu-repo/semantics/altIdentifier/pmid/9291249 Journal of oral rehabilitation. - 1997 Acid Etching, Dental Ceramics Crowns Dentin Dentin-Bonding Agents Humans In Vitro Techniques Materials Testing Molar Random Allocation Surface Properties Film thickness of various dentine bonding agents. http://purl.org/coar/resource_type/c_6501