Back
Full-text
Journal article

Reproducibility of a new signal processing technique to assess joint sway during standing.

  • Rast FM School of Health Professions, Institute of Physiotherapy, Zurich University of Applied Sciences, Winterthur, Zurich, Switzerland. Electronic address: fabian.rast@zhaw.ch.
  • Graser JV School of Health Professions, Institute of Physiotherapy, Zurich University of Applied Sciences, Winterthur, Zurich, Switzerland; Rehabilitation Center for Children and Adolescents, University Children׳s Hospital Zurich, Affoltern am Albis, Zurich, Switzerland.
  • Meichtry A School of Health Professions, Institute of Physiotherapy, Zurich University of Applied Sciences, Winterthur, Zurich, Switzerland.
  • Ernst MJ School of Health Professions, Institute of Physiotherapy, Zurich University of Applied Sciences, Winterthur, Zurich, Switzerland.
  • Bauer CM School of Health Professions, Institute of Physiotherapy, Zurich University of Applied Sciences, Winterthur, Zurich, Switzerland.
  • 2016-12-08
Published in:
  • Journal of biomechanics. - 2017
Motion analysis
Postural control
Reproducibility of results
Signal processing
Spine
Adult
Biomechanical Phenomena
Female
Humans
Lumbar Vertebrae
Male
Movement
Postural Balance
Posture
Pressure
Reproducibility of Results
Signal Processing, Computer-Assisted
English Postural control strategies can be investigated by kinematic analysis of joint movements. However, current research is focussing mainly on the analysis of centre of pressure excursion and lacks consensus on how to assess joint movement during postural control tasks. This study introduces a new signal processing technique to comprehensively quantify joint sway during standing and evaluates its reproducibility. Fifteen patients with non-specific low back pain and ten asymptomatic participants performed three repetitions of a 60-second standing task on foam surface. This procedure was repeated on a second day. Lumbar spine movement was recorded using an inertial measurement system. The signal was temporally divided into six sections. Two outcome variables (mean absolute sway and sways per second) were calculated for each section. The reproducibility of single and averaged measurements was quantified with linear mixed-effects models and the generalizability theory. A single measurement of ten seconds duration revealed reliability coefficients of .75 for mean absolute sway and .76 for sways per second. Averaging a measurement of 40 seconds duration on two different days revealed reliability coefficients higher than .90 for both outcome variables. The outcome variables' reliability compares favourably to previously published results using different signal processing techniques or centre of pressure excursion. The introduced signal processing technique with two outcome variables to quantify joint sway during standing proved to be a highly reliable method. Since different populations, tasks or measurement tools could influence reproducibility, further investigation in other settings is still necessary. Nevertheless, the presented method has been shown to be highly promising.
Language
  • English
Open access status
green
Identifiers
Persistent URL
https://sonar.ch/global/documents/47362
Statistics
Document views: 47 File downloads:
  • Full-text: 0